VTech Baby Toy 91 002831 011 US User Manual

User’s Manual  
© 2013 VTech  
Printed in China  
US  
91-002831-011  
 
INTRODUCTION  
Thank you for purchasing the VTech® Go! Go! Smart WheelsFast  
Track Launcher learning toy!  
Launch, jump and crash your way to learning fun with the Go! Go!  
Smart WheelsFast Track Launcher by VTech®! Your child will  
develop hand/eye coordination and motor skills as they launch the  
included Go! Go! Smart Wheels™ race car and crash through barriers  
or cross the finish line and jump the ramp! Watch the race car or other  
SmartPoint™ vehicles (each sold separately) race and crash as they  
respond to two SmartPoint™ locations to add to the role-play fun. It’s  
playtime with miles of learning!  
Launcher  
Jump Track  
Race Car  
Two  
Tires  
Two SmartPoint™  
Locations  
Crash Platform  
Reconfigure the track pieces for more ways to play!  
 
2
INCLUDED IN THIS PACKAGE  
- One user’s manual  
Launcher  
Y-Shaped Track  
Race Car  
Crash Platform  
Jump Track  
Two Tires  
Finish Gate  
Two End Tracks  
Two Straight Tracks  
WARNING:  
All packing materials, such as tape, plastic sheets, packaging  
locks and tags are not part of this toy, and should be discarded  
for your child’s safety.  
ATTENTION:  
Pour la sécurité de votre enfant, débarrassez-vous de tous  
les produits d’emballage tels que rubans adhésifs, feuilles de  
plastique, attaches et étiquettes. Ils ne font pas partie du jouet.  
NOTE:  
Please keep this user’s manual as it contains important  
information.  
 
3
GETTING STARTED  
BATTERY INSTALLATION  
1. Make sure the unit is turned OFF.  
2. Locate the battery cover on the bottom  
of the vehicle. Use a screwdriver to  
loosen the screw.  
3. Install 2 new ‘AAA’ (AM-4/LR03)  
batteries following the diagram inside  
the battery box. (The use of new  
alkaline batteries is recommended for  
maximum performance.)  
4. Replace the battery cover and tighten  
the screw to secure.  
BATTERY NOTICE  
Use new alkaline batteries for maximum performance.  
Use only batteries of the same or equivalent type as recommended.  
Do not mix different types of batteries: alkaline, standard (carbon-  
zinc) or rechargeable (Ni-Cd, Ni-MH), or new and used batteries.  
Do not use damaged batteries.  
Insert batteries with the correct polarity.  
Do not short-circuit the battery terminals.  
Remove exhausted batteries from the toy.  
Remove batteries during long periods of non-use.  
Do not dispose of batteries in fire.  
Do not charge non-rechargeable batteries.  
Remove rechargeable batteries from the toy before charging  
(if removable).  
Rechargeable batteries are only to be charged under adult  
supervision.  
 
4
PRODUCT FEATURES  
1. ON/OFF/SWITCH  
To turn the unit ON, slide the ON/OFF  
SWITCH on the race car to the ON  
(
) position.To turn the unit OFF, slide  
the ON/OFF SWITCH to the OFF (  
)
position.  
2. AUTOMATIC SHUT-OFF  
To preserve battery life, the race car included with the VTech®  
Go! Go! Smart Wheels™ Fast Track Launcher will automatically  
power-down after approximately 60 seconds without input.The unit  
can be turned on again by pressing the light-up driver button or  
pushing the race car quickly.  
RACE CAR ACTIVITIES  
1. Slide the ON/OFF SWITCH to turn the  
unit ON.You will hear race car sounds,  
a song and a phrase.The light will flash  
with the sounds.  
2. Press the LIGHT-UP DRIVER BUTTON  
to hear race car sounds, songs and  
phrases. The light will flash with the  
sounds.  
 
5
3. Push the race car to hear fun sounds  
and melodies. While the melody is  
playing, push the race car again to add  
in fun sounds on top of the melody.The  
light will flash with the sounds.  
4. For added fun, the race car interacts  
with other VTech® Go! Go! Smart  
Wheels™ playsets. Simply roll the  
race car over one of the playset’s  
SmartPoints™ to see the race car’s  
light flash and to hear greetings, fun  
sounds, short tunes and sing-along  
songs (each playset sold separately).  
FAST TRACK LAUNCHER ACTIVITIES  
1. Place the launcher on the y-shaped  
track and point the launcher in one of  
three directions.  
2. Make sure the red piece on the front  
of the launcher is in launch position  
inside the launcher. Place the race car  
in front of the launcher and press the  
red launch button to launch the race  
car.  
 
6
CARE & MAINTENANCE  
1. Keep the unit clean by wiping it with a slightly damp cloth.  
2. Keep the unit out of direct sunlight and away from any direct heat  
source.  
3. Remove the batteries when the unit will not be in use for an extended  
period of time.  
4. Do not drop the unit on hard surfaces and do not expose the unit  
to moisture or water.  
TROUBLESHOOTING  
If for some reason the program/activity stops working or malfunctions,  
please follow these steps:  
1. Please turn the unit OFF.  
2. Interrupt the power supply by removing the batteries.  
3. Let the unit stand for a few minutes, then replace the batteries.  
4. Turn the unit ON. The unit should now be ready to play again.  
5. If the product still does not work, replace with a new set of batteries.  
If the problem persists, please call our Consumer Services Department  
at 1-800-521-2010 in the U.S. or 1-877-352-8697 in Canada, and a  
service representative will be happy to help you.  
For information on this product’s warranty, please call VTech® at  
1-800-521-2010 in the U.S. or 1-877-352-8697 in Canada.  
 
7
IMPORTANT NOTE:  
Creating and developing Infant Learning products is accompanied  
by a responsibility that we at VTech® take very seriously.We make  
every effort to ensure the accuracy of the information, which forms  
the value of our products. However, errors sometimes can occur.  
It is important for you to know that we stand behind our products  
and encourage you to call our Consumer Services Department at  
1-800-521-2010 in the U.S. or 1-877-352-8697 in Canada, with  
any problems and/or suggestions that you might have. A service  
representative will be happy to help you.  
Note:  
This equipment has been tested and found to comply with the limits for  
a Class B digital device, pursuant to Part 15 of the FCC Rules. These  
limits are designed to provide reasonable protection against harmful  
interference in a residential installation. This equipment generates, uses  
and can radiate radio frequency energy and, if not installed and used in  
accordance with the instructions, may cause harmful interference to radio  
communications. However, there is no guarantee that interference will not  
occur in a particular installation. If this equipment does cause harmful  
interference to radio or television reception, which can be determined by  
turning the equipment off and on, the user is encouraged to try to correct  
the interference by one or more of the following measures:  
Reorient or relocate the receiving antenna  
Increase the separation between the equipment and receiver  
Connect the equipment into an outlet on a circuit different from that to  
which the receiver is connected  
Consult the dealer or an experienced radio/TV technician for help  
Caution: Changes or modifications not expressly approved by the party  
responsible for compliance could void the user’s authority to  
operate the equipment.  
 
8
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.  
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:  
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND  
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,  
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED  
OPERATION.  
CAN ICES-3 (B)/NMB-3(B)  
 
9

Tiffen Camera Accessories Pro RL User Manual
Timex Clock Radio T121 IB User Manual
Transition Networks TV Converter Box AR CF 02 User Manual
Uniden Cordless Telephone EXI2960 User Manual
United States Stove Home Security System 1602M User Manual
Universal Security Instruments Carbon Monoxide Alarm CD 9000 User Manual
Viking Oven VEDO127 User Manual
Vivotek Digital Camera IP7131 User Manual
Vizio Music Mixer S4251w User Manual
Weber Gas Grill 42390 User Manual