VTech Battery Charger LS6325 User Manual

Battery installation and charging  
Push to talk (PTT)  
Make, answer and end a call  
Make a call  
Install the battery as shown below. After  
installing the battery, you may be able to make  
and receive short calls. For best performance,  
charge the handset battery for at least 16 hours  
before use.  
You can directly broadcast messages from one  
handset to the speakerphone of one or all other  
handsets. Any handset you call can respond by  
pressing PUSH TO TALK to begin a two-way  
communication.  
1. Press  
/FLASH or  
.
You hear a dial tone.  
2. Dial the number.  
Quick start guide  
When the connection is made, both the caller  
and the destination handsets display Press  
and hold [PTT] to talk and beep once.  
Only one handset can be talk at a time. To do  
so, press and hold PUSH TO TALK.  
Make a predial call  
for models LS6325/LS6325-2/LS6325-3/  
LS6325-4/LS6325-5/LS6326-5  
1
2
1. Dial the number.  
Plug the battery  
If the battery  
2. Press  
/FLASH or  
.
connector securely  
into the socket inside  
the handset battery  
compartment, matching  
the color-coded label.  
compartment cover is on  
the handset, press on the  
indentation and slide the  
cover to remove.  
Answer a call  
For complete PTT instructions, please refer  
to your user’s manual.  
Install the telephone base and  
charger(s)  
Install the telephone base and charger(s) as  
shown below.  
Press  
/FLASH,  
or any of the dialing keys  
(0-9, #, TONE ).  
End a call  
Press OFF/CLEAR or put the handset in the  
Telephone  
wall jack  
Telephone  
base power  
adapter  
telephone base or charger.  
Charger  
adapter  
If you have  
DSL high  
speed  
Electrical  
Internet  
outlet not  
4
3
service, a  
controlled by  
a wall switch  
DSL filter (not  
included) is  
required.  
Place the battery with  
Align the cover flat  
the label THIS SIDE UP against the battery  
facing up and the wires compartment, then slide  
inside the battery  
compartment.  
it towards the center of  
the handset until it clicks  
into place.  
Telephone  
line cord  
Charger  
Telephone base  
• Use only the power adapters and batteries  
supplied with your VTech telephone.  
5
• For complete feature instructions, please  
refer to your user’s manual.  
Charge the handset by  
placing it in the telephone  
base or charger. The  
CHARGE  
light  
CHARGE light is on when  
the handset charges.  
 

Technics Electronic Keyboard SX P30 User Manual
Timex Watch W 263 User Manual
Topcom Cordless Telephone M1250 User Manual
Toshiba Marine Radio C650 User Manual
Toshiba Personal Computer PROA660 User Manual
Tripp Lite TV Cables N001 025 GY R User Manual
Uniden Cordless Telephone 900 MHz User Manual
ViewSonic Projector PJ650 User Manual
ViewSonic Projector PJ3589 User Manual
Vizio Flat Panel Television XMT1200MS User Manual