Vtech Telephone Ls6325 5 User Manual

Battery installation and charging  
Push to talk (PTT)  
Make, answer and end a call  
Make a call  
Install the battery as shown below. After  
installing the battery, you may be able to make  
and receive short calls. For best performance,  
charge the handset battery for at least 16 hours  
before use.  
You can directly broadcast messages from one  
handset to the speakerphone of one or all other  
handsets. Any handset you call can respond by  
pressing PUSH TO TALK to begin a two-way  
communication.  
1. Press  
/FLASH or  
.
You hear a dial tone.  
2. Dial the number.  
Quick start guide  
When the connection is made, both the caller  
and the destination handsets display Press  
and hold [PTT] to talk and beep once.  
Only one handset can be talk at a time. To do  
so, press and hold PUSH TO TALK.  
Make a predial call  
for models LS6325/LS6325-2/LS6325-3/  
LS6325-4/LS6325-5/LS6326-5  
1
2
1. Dial the number.  
Plug the battery  
If the battery  
2. Press  
/FLASH or  
.
connector securely  
into the socket inside  
the handset battery  
compartment, matching  
the color-coded label.  
compartment cover is on  
the handset, press on the  
indentation and slide the  
cover to remove.  
Answer a call  
For complete PTT instructions, please refer  
to your user’s manual.  
Install the telephone base and  
charger(s)  
Install the telephone base and charger(s) as  
shown below.  
Press  
/FLASH,  
or any of the dialing keys  
(0-9, #, TONE ).  
End a call  
Press OFF/CLEAR or put the handset in the  
Telephone  
wall jack  
Telephone  
base power  
adapter  
telephone base or charger.  
Charger  
adapter  
If you have  
DSL high  
speed  
Electrical  
Internet  
outlet not  
4
3
service, a  
controlled by  
a wall switch  
DSL filter (not  
included) is  
required.  
Place the battery with  
Align the cover flat  
the label THIS SIDE UP against the battery  
facing up and the wires compartment, then slide  
inside the battery  
compartment.  
it towards the center of  
the handset until it clicks  
into place.  
Telephone  
line cord  
Charger  
Telephone base  
• Use only the power adapters and batteries  
supplied with your VTech telephone.  
5
• For complete feature instructions, please  
refer to your user’s manual.  
Charge the handset by  
placing it in the telephone  
base or charger. The  
CHARGE  
light  
CHARGE light is on when  
the handset charges.  

Philips Silver 389 User Manual
Pinnacle Products International Protemp Bcb 36 Bdf User Manual
Ricoh Network Guide User Manual
Samsung As24w User Manual
Samsung Aw1210 User Manual
Samsung Scx 4100 User Manual
Sanyo Cr704gdzh8 User Manual
Sanyo Twicell Hr Aa User Manual
Soleus Air Sg Wac 25ese C User Manual
Sony Found Not Kdl 42v4100 User Manual